Skil 3800-02 Operating/Safety Instructions Manual page 5

"READ ALL INSTRUCTIONS" — Failure to follow the SAFETY RULES identified by BULLET (l) symbol listed
!
WARNING
BELOW and other safety precautions, may result in serious personal injury.
Do not allow familiarity gained from frequent use of your miter saw to become commonplace. Always remember that
•
a careless fraction of a second is sufficient to inflict severe injury.
• THINK SAFETY! SAFETY IS A COMBINATION OF OPERATOR'S COMMON SENSE, KNOWLEDGE OF THE SAFETY
AND OPERATING INSTRUCTIONS AND ALERTNESS AT ALL TIMES WHEN THE MITER SAW IS BEING USED.
THE WARNINGS SHOWN BELOW CAN BE FOUND ON YOUR TOOL. THESE WARNINGS ARE ONLY A
!
WARNING
CONDENSED FORM OF THE MORE DETAILED SAFETY RULES AND PRECAUTIONS THAT APPEAR IN
YOUR OWNER'S MANUAL. THEY SERVE AS A REMINDER OF ALL SAFETY RULES NEEDED FOR SAFE OPERATION OF
THIS MITER SAW.
Safety
DESIGNATED DANGER ZONE.
AVOID POSITIONING HANDS,
FINGERS OR ARMS IN THE
AREA DESIGNATED BY THIS
SYMBOL.
Ø10"(254mm) COMPOUND MITER SAW
120V~ 50/60Hz 15A n
WARNING
protection. s Use saw blade rated 4,800/min or greater.
without functioning guard system. If guard doesn't operate smoothly, have
it serviced. After changing blade return guard to operating position.
hands a safe distance from saw blade. Always keep outside of No-Hands
zone. s Hold or clamp workpiece against base and fence. Never perform
any operation freehand.
or arms across the projected saw blade path. With motor OFF, make a Dry-
Run to be aware of the blade's reach.
the down position and wait for blade to stop before removing cutoff pieces or
changing settings.
s
in damp locations.
s
For bevel or compound cutting, adjust sliding
s
fence clear of blade path and guard system.
Robert Bosch Tool Corp., Mount Prospect, IL Made in China
"SAVE THESE INSTRUCTIONS"
5
3800
F012380002
4,800/min (RPM)
o
To reduce risk of injury, user must read and understand
the instruction manual. s Wear eye and respiratory
s Do not use saw
s Keep
s Do not Cross-Hand cut. Never place your hands
s After turning saw OFF, keep saw in
To avoid electrical shock, do not expose to rain or use
When servicing use only identical replacement parts.
E152254
6A3
LISTED TOOL 293G