Maintaining Your Belt/Disc Sander; Troubleshooting - Skil 3375-01 Operating/Safety Instructions Manual

SM 2610957110 05-08 6/5/08
To reduce the risk of injury, turn
!
WARNING
power switch "OFF" and remove
plug from the power source outlet before
maintaining or lubricating your sander.
Frequently blow out any dust that may
accumulate inside the motor.
An occasional coat of paste wax on the work table
will allow the wood being cut to glide smoothly
across the work surface.
Certain
!
CAUTION
solvents damage plastic parts.
Including: gasoline, carbon tetrachloride,
chlorinated cleaning solvents, ammonia and
household detergents that contain ammonia.
Avoiding use of these and other types of cleaning
agents minimizes the probability of damage.
Turn switch "OFF" and always remove
!
WARNING
plug from the power source before trouble
shooting.
TROUBLE: WILL NOT START
PROBLEM 1. Power cord is not plugged in.
2. Fuse or circuit breaker tripped.
3. Cord damaged.
4. Burned out switch.
REMEDY 1. Plug in.
2. Replace fuse or reset tripped circuit breaker.
3. Have cord replaced by an Authorized Skil
Service Center or Service Station.
4. Have switch replaced by an Authorized Skil
Service Center or Service Station.
7:36 AM Page 17

Maintaining Your Belt/Disc Sander

Maintenance
GENERAL
cleaning agents

Troubleshooting

To avoid shock or fire hazard, if the
!
WARNING
power cord is worn, cut or damaged
in any way, have it replaced immediately.
All repairs, electrical or mechanical,
!
WARNING
should be attempted only by trained
repairmen. Contact the nearest Skil Factory Service
Center, Authorized Skil Service Station or other com-
petent repair service. Use only Skil replacement
parts; any other may create a hazard.
Use only recommended accessories. Follow
instructions that accompany accessories. Use of
improper accessories may cause hazards.
and
TROUBLE: DOES NOT COME UP TO SPEED
PROBLEM 1. Extension cord too light or too long.
2. Low house voltage.
REMEDY 1. Replace with adequate cord.
2. Contact your electric company.
17.
Accessories