Panasonic TH-86EQ1W Operating Instructions Manual page 10

Notes on Using Wired LAN
When setting up the Display at a place, where
electric statistic occurs often, take a sufficient
antistatic measure before start using.
When the Display is used at a location, where static
•
electricity occurs often, such as on a carpet, a wired
LAN communication is disconnected more often.
In that case, remove static electricity and the noise
source that may cause problems with an antistatic
mat, and re-connect the wired LAN.
In rare cases, the LAN connection is disabled due
•
to static electricity or noise. In that case, turn off the
power of the Display and the connected devices once
and then re-turn on the power.
The Display may not work properly due to strong
radio wave from the broadcast station or the radio.
If there is any facility or equipment, which outputs
•
strong radio wave, near the installation location, set
up the Display at a location sufficiently far from the
source of the radio wave. Or, wrap the LAN cable
connected to the LAN terminal by using a piece of
metal foil or a metal pipe, of which is grounded at
both ends.
Request Regarding Security
When using this unit, take safety measures against
the following incidents.
Personal information being leaked via this unit
•
Unauthorized operation of this unit by a malicious
•
third party
Interfering or stopping of this unit by a malicious third
•
party
Take sufficient security measures.
Set a password for the LAN control and restrict the
•
users who can log in.
Make your password difficult to guess as much as
•
possible.
Change your password periodically.
•
Panasonic Corporation or its affiliate companies will
•
never ask for your password directly. Do not divulge
your password in case you receive such inquiries.
The connecting network must be secured by a
•
firewall, etc.
When disposing the product, initialize the data before
•
disposing. ([Shipping])
10
English
Cleaning and maintenance
First, remove the mains plug from the mains socket.
Gently wipe the surface of the liquid crystal panel or
cabinet by using a soft cloth to remove dirt.
To remove stubborn dirt or fingerprints on the surface
•
of the liquid crystal panel, dampen a cloth with diluted
neutral detergent (1 part detergent to 100 parts
water), wring out the cloth firmly, and then wipe away
the dirt. Finally, wipe away all the moisture with a dry
cloth.
If water droplets get inside the unit, operating
•
problems may result.
Note
●
The surface of the liquid crystal panel is specially
treated. Do not use a hard cloth or rub the surface
too hard, otherwise this may cause scratches on the
surface.
Usage of a chemical cloth
Do not use a chemical cloth for the liquid crystal panel
•
surface.
Follow the instructions for the chemical cloth to use it
•
for the cabinet.
Avoid contact with volatile substances such as
insect sprays, solvents and thinner.
This may cause damage to the cabinet or cause
•
peeling of the paint. Furthermore, do not leave it in
contact with a rubber or PVC substance for a long
time.
Disposal
When disposing the product, ask your local
authority or dealer about the correct methods of
disposal.