Makita 4322 Instruction Manual page 8

1. Hex wrench
2. Bolt
3. Base
1 2
1. Graduation
2. Edge
8
Bevel cutting
002746
CAUTION:
• Always be sure that the tool is switched off and unplugged before tilting
the base.
• Raise the dust cover all the way before making bevel cuts.
With the base tilted, you can make bevel cuts at any angle between 0° and 45°
(left or right).
Loosen the bolt on the back of the base with the hex wrench. Move the base
002748
so that the bolt is positioned in the center of the cross-shaped slot in the base.
1
2
3
Tilt the base until the desired bevel angle is obtained. The edge of the motor
002747
housing indicates the bevel angle by graduations. Then tighten the bolt to
secure the base.
Front flush cuts
002756
Loosen the bolt on the back of the base with the hex wrench and slide the
base all the way back. Then tighten the bolt to secure the base.