Technical Data - LinMot S01-24/500 Installation Manual

Installation Guide Power Supply

3 Technical Data

Input
Input voltage range Vi
Power frequency
Efficiency
Input current limitation
Fuse - internal
Fuse - external
Output
Preset range Vo
Max. Ouputpower
Powerboost
(only in boostmode)
Operation indicator
Ripple
Noise voltage (20MHz)
Temperature coefficient
Switch on / switch off
Start-up delay
Rise time
Back feeding voltage
Serial connection
Parallel connection
Regulation
Line regulation
Load regulation
Response time
Protection and Controlling
Overvoltage protection
(OVP)
Undervoltage monitoring
Current limitation
Overtemperature protection
Relay contact
Remote OFF
NTI AG / LinMot
S01-24/500
90...132VAC / 180...264 V automatical switchover
typ. 86%
≤ 70A typ. in cold state, ≤ 150A
peak
16 A (IEC), 20 A (USA) trip characterstic C, D or K
22 - 29VDC,
factory setting 24VDC ± 0.5%
(Vo will be saved after 1s)
480W - Powerboost 720W (Vo ≥ Vo
Boost 500ms up to 150% I
after that min. 500ms break necessary
green LED for ok / red LED for error
No Vo overshoot (soft-start)
40 ms typ.
up to 35Vdc
yes (max. 2 identical power supplies)
yes, only in parallel mode (max. 3 identical power supplies)
< 0.2% for Vo at Vi
< 0.5% for Vo at Io 0 - 100% boost mode
< 3.0% for Vo at Io 0 - 100% parallel m.
approx. 31 Vdc
approx. 18 Vdc
105 - 140% I
output permanent short-circuit proof
Switches off if inside temperature is too high, reconnection with hysteresis
Relay contact (max. 80V / 1A / 30W),
changing at Vo < 18V / 35V / 52V or
OVP from OK to FAIL (red LED)
External switch-off with with 4-60Vdc/5mA
Power range 480 W
50/60Hz
peak
16ATH / 250VAC
factory setting 72VDC ± 0.5%
(Vo will be saved after 1s)
possible,
nom
120mV typ.
ss
200mV typ.
ss
≤ 0,025% / K
< 1,5s (at 230VAC)
- Vi
min max
typ. 1ms at Io 20 - 80%
automatical repeating
(see diagram)
nom
DE
S01-72/500
typ. 88%
in hot state
54 - 80VDC,
)
nom
80 ms typ.
up to 100 Vdc
approx. 88 Vdc
approx. 52 Vdc
Page 5 / 12