Table of Contents
Advertisement
Installation of this unit
≥ Tighten one screw to secure the gear rack.
≥ Turn the right clamping lever clockwise to secure the
gear rack. Check that the black part of the gear rack is
lower than the module's border line.
The gear rack is fully lowered.
Right clamping lever
≥ Turn the left clamping lever clockwise to secure the
gear rack. Check that the black part of the gear rack is
lower than the module's border line.
The gear rack is fully lowered.
Left clamping lever
Appendix
Border line
Border line
61
4
Check the changer unit installation.
≥ Confirm that a 0.09 mm (0.004q) gap gauge cannot be
inserted between the four changer unit seats at the
front and back and the bottom panel of the Bottom
Module.
You can check the front through the
opening if the seats of the changer unit
are in contact with the bottom panel.
Advertisement
Table of Contents
