Extension - Panasonic LB-DH7 Series Installation Manual

Installation of this unit

Extension

This unit can be extended by adding the Extension
Module equipped with the Control Unit (LB-XC82) or the
Writer Unit (LB-XD73A).
≥ For details on how to install the Control Unit or the Writer
Unit into the Extension Unit, refer to "Installing of the Control
Unit/Writer Unit" ( 41).
1
Remove the bottom panel of the Bottom
Module.
≥ Remove the four screws.
2
Check the changer unit installation.
≥ Confirm that the changer unit is correctly installed in
the Bottom Module. Confirm that a 1.5 mm (0.06q) gap
gauge cannot be inserted between the changer unit
seats and the bottom panel of the Bottom Module.
Changer unit
Bottom panel of the
Bottom Module
Confirm that a 1.5 mm (0.06q) gap gauge cannot be inserted.
≥ If the 1.5 mm (0.06q) gap gauge can be inserted, it will
not be possible to turn off the drive transmission of the
changer unit. Contact the vendor.
Installation
Bottom panel
34
3
Turn off the drive transmission of the changer
unit.
≥ Insert your hands into the opening to left and right.
Then push the clutch release arm.
≥ Make sure that the clutch release arm is stationary and
does not return.
Engage Clutch
(Default/Shipping)
≥ Do not touch the levers in the changer unit.
Levers in the changer unit
Clutch release
arm
Release Clutch
(Service)