Table of Contents
Advertisement
Installation of this unit
Set up
Startup
After installing the unit, plug in the power supply, and turn on
the unit.
Insert the AC cable plug into the AC outlet.
[When using an external power supply with no power
switch (including certain external power supply models
that have been validated to work with the unit)]
The unit turns on the AC cable plug is inserted. Check the
status by referring to the pertinent external power supply
manual. If any trouble is found, pull out the AC cable plug.
[When using an external power supply with a power
switch]
Check the status by referring to the pertinent external power
supply manual. If any trouble is found, pull out the AC cable
plug.
After turning on the unit, turn on the server connected to the
unit.
After the server is turned on, the unit is automatically
initialized. To check the progress of the initialization, go to
"System Status" (A) in the right pane of the Web interface, or
go to "Monitor"
"System"
When the initialization is complete, "Ready" is displayed.
Before using the Web interface, configure the network
settings, such as the IP address setting of the server to be
connected to the unit.
When using the unit, operate the Web interface and make the
following initial settings. (
For details on how to operate the Web interface, refer to the
Operator Guide.
≥ Keep the password not to forget.
≥ If a password is compromised, it may be misused by a
third party. It is a customer's responsibility to manage a
password. Panasonic assumes no responsibility for
password misuse.
≥ Panasonic assumes no responsibility for damages due
to malfunctions, hang-ups, and other trouble caused by
the unintended use of the unit with a device, software
etc. whose operation with the unit is not validated by
Panasonic.
"Status" (B).
57)
56
Advertisement
Table of Contents
