Priority Channel Programming - Ericsson LBI-38862A Operator's Manual

16
2. To add a channel to the scan list, select the channel
and press the "S" button while the channel is flash-
ing in the display. The number will be displayed
continuously to indicate that it is stored on the scan
list.
3. To select the next channel to be programmed and
repeat the procedure above.
When st opped on a channel i n the
Programming Mode, the display will blink if
the channel is not in the scan list, and be on
continuous if already included.
4. To delete a channel from the scan list, press the
"1" auxiliary button LED. The display will change
from continuous to flashing, indicating the dele-
tion was successful.
After selecting a channel to be deleted, use the
"1" button to delete it from the scan list.
5. After you have completed programming your scan
list, press the "P" button again, the radio will sound
the prompt tone and display "Prog".
6. To save the scan list, press the "P" button again to
enter the scan list into the micro-processor mem-
ory.
7. To exit the programming mode, press the "2"
button.
NOTE
NOTE