Table of Contents
Advertisement
ATTACH PROPANE CYLINDER
Use propane cylinder with a minimum capacity of 4.5 Kg and a
maximum capacity of 9 Kg.
1) Screw adapter hose into the regulator connection of the Weber• gas grill.
2) Connect the QCC1 fitting into a propane cylinder. Tighten with hand wheel.
WARNING: Do not use a wrench to tighten the connection.
Using a wrench could damage the regulator coupling and could
cause a leak.
3) Test connections for leaks by wetting the connections with soap and water solution,
and watching for bubbles. If bubbles form or if a bubble grows there is a leak.
Note — Since some leak test solutions, including soap and water, may be slightly
corrosive, all connections should be rinsed with water after checking for leaks.
WARNING: If there is a leak, turn OFF gas. DO NOT OPERATE
THE GRILL. Check connection for tightness. If leak persists,
contact the Customer Service Representative in your area by
using the contact information on our web site. Log onto www.
weber.com
®
.
Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you
check for leaks. Sparks or flames will result in a fire or explosion which can cause serious bodily injury or death,
Do not store a spare LP-gas cylinder under or near this appliance. Never fill the cylinder beyond 80 percent full. If
the instructions are not followed exactly, a fire causing death or serious injury may occur.
CHECK FOR GAS LEAKS
Check for leaks by wetting the connections with the soap and water solution and
watching for bubbles. If bubbles form, or if a bubble grows, there is a leak.
Note - Since some leak test solutions, including soap and water, may be slightly
corrosive, all connections should be rinsed with water after checking for leaks.
1) Regulator to propane cylinder connection.
WARNING: If there is a leak at connection (1), disconnect
propane cylinder. Reconnect and retighten connection. If a leak
persists after retightening the propane cylinder, turn OFF the
gas. DO NOT OPERATE THE GRILL.
Contact the Customer Service Representative in your area by
using the contact information on our web site. Log onto www.
®
.
weber.com
2) Valve to-regulator connections.
WARNING: If there is a leak at connection (2) turn OFF the
gas. DO NOT OPERATE THE GRILL. Contact the Customer
Service Representative in your area by using the contact
information on our web site. Log onto www.weber.com
When leak checks are complete, turn gas supply OFF at the source and rinse
connections with water.
GAS INSTRUCTIONS
GAS INSTRUCTIONS
DANGER
and damage to property.
DANGER
®
.
7
Advertisement
Table of Contents
