Dmx Linking; Dmx Connection - Chauvet Colorado 1-Quad IP Quick Reference Manual

EN

DMX Linking

DMX Connection

Master/Slave
Connection
Mounting
Product
Mounting
Diagram
Control Panel
Description
Passcode
The COLORado™ 1-Quad IP will work with a DMX controller using a regular
DMX serial connection.
www.chauvetpro.com.
The COLORado™ 1-Quad IP uses a regular DMX data connection for its
DMX personalities: TOUR, TR16, FULL, ARC.1, AR1.D, ARC.2, AR2.D,
AR2.S, PIX1, PIX2, and HSV. See the User Manual to connect and configure
for DMX operation.
Note: For optimum control of the 16-bit dimming channels in the TR16 and
FULL personalities, be sure that both dimming curves in SET > DIM and
SET > CURV are set to OFF.
The COLORado™ 1-Quad IP uses the DMX data connection for its
Master/Slave mode. See the User Manual to connect and configure for
Master/Slave operation.
Overhead Mounting
Button
Exits from the current menu or function
<MENU>
Enables the currently displayed menu or sets the currently
<ENTER>
selected value into the selected function
Navigates upwards through the menu list and increases the
<UP>
numeric value when in a function
Navigates downwards through the menu list and decreases
<DOWN>
the numeric value when in a function
After being prompted, enter the following passcode by pressing:
·
<UP>, <DOWN>, <UP>, <DOWN>, <ENTER>
This password cannot be changed and must be used whenever prompted.
COLORado™ 1-Quad IP QRG
A DMX
Mounting Clamp
(such as CLP-15 or
CLP-15N from
CHAUVET®)
Safety Cable
(such as CH-05
from CHAUVET®)
Secure the safety cable using
the passageway on the back
of the product
Function
3
Primer is available
Floor Mounting
from