Crosley XSS23G Owner's Manual And Installation Instructions page 13

Ice and Water Dispenser
Using the Dispenser
Select CUBED ICE ,
CRUSHED ICE
or WATER .
Press the glass gently against
the top of the dispenser
cradle .
The spill shelf is not self-
draining . To reduce water
spotting, the shelf and its grille
should be cleaned regularly .
If no water is dispensed
when the refrigerator is first
installed, there may be air in the water line system .
Press the dispenser arm for at least two minutes to
remove trapped air from the water line and to fill the
water system . To flush out impurities in the water line,
throw away the first six glassfuls of water .
CAUTION
Laceration Hazard
■ Never put fingers or any other object into ice crusher
discharge opening . Doing so can result in contacting
the ice crushing blades and lead to serious injury or
amputation
■ Use a sturdy glass when dispensing
ice . A delicate glass may break and
result in personal injury .
Important Facts About Your Dispenser
■ D o not add ice from trays or bags to the storage
drawer . It may not crush or dispense well .
■ A void overfilling glass with ice and use of narrow
glasses . Backed-up ice can jam the chute or cause
the door in the chute to freeze shut . If ice is blocking
the chute, poke it through with a wooden spoon .
■ B everages and foods should not be quick-chilled
in the ice storage drawer . Cans, bottles or food
packages in the storage drawer may cause the
icemaker or auger to jam .
■ T o keep dispensed ice from missing the glass, put
the glass close to, but not touching, the dispenser
opening .
49-1000105 Rev. 0
(on some models .)
Locking the Dispenser
Press the LOCK pad for 3 seconds to
lock the dispenser and control panel . To
unlock, press and hold the pad again for
3 seconds .
Dispenser Light
This pad turns the light in the dispenser on and off .
The light also comes on when the dispenser cradle is
pressed . For models with a bulb, if the light burns out,
it should be replaced with a 6 watt
12V maximum bulb . For LED models,
Spill Shelf
contact Factory Service .
Quick Ice
When you need ice in a hurry, press
this pad to speed up ice production . This will increase
ice production for the following 48
hours or until you press the pad again .
Door Alarm
To set the alarm, press this pad until
the indicator light comes on . This
alarm will sound if either door is open for more than
3 minutes . The light goes out and the beeping stops
when you close the door .
■ S ome crushed ice may be dispensed even though
■ A fter crushed ice is dispensed, some water may drip
■ S ometimes a small mound of snow will form on the
(on some models)
(on some models)
you selected CUBED ICE . This happens occasionally
when a few cubes accidentally get directed to the
crusher .
from the chute .
door in the ice chute . This condition is normal and
usually occurs when you have dispensed crushed ice
repeatedly . The snow will eventually evaporate .
13