Troubleshooting; Specifications; Replacement And Associated Parts; Fcc Compliance Statement - Beurer LB 37 Instructions For Use Manual

7. Troubleshooting

Problem
On/Off Button does not
illuminate
On/Off Button illuminates
red
No mist
Mist has strange smell
Strange noise
Mist escapes underneath
Water Reservoir
On/Off Button illuminates
red even when Water
Reservoir is full

8. Specifications

Dimensions (L x W x H)
Power Supply
Rated power
Recommended room size
Capacity of the water reservoir approx. 67 fl oz (2 liters)
Evaporation

9. Replacement and Associated Parts

Contact Customer Service to order replacement parts. Part numbers are below.
Item
10 aroma pads

10. FCC Compliance Statement

This device complies with part 18 of the FCC rules.
Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2.
This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a consumer ISM equipment,
pursuant to Part 18 of the FCC Rules. These limits are designed to provide reasonable protection against harm-
ful interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
Cause
Power Cord not getting power or
device is in Night Mode
Water level is too low
Water level is too low
Device is new
Water is not fresh
Pad needs to be changed
Water Reservoir positioned incor-
rectly on the Base
Water level is too low
Device is not level
Water Reservoir positioned incor-
rectly on the Base
Mineral deposits prevent proper
attachment of Water Reservoir to
Base
Incorrect water level detected
8.27 in x 5.12 in x 10.04 in (21.0 cm x 13.0 cm x 25.5 cm)
100 – 240 VAC / 50 – 60 Hz
20 W max
up to 215 square feet (20 m
up to 6.76 fl oz/hour (200 ml/hour)
This unit is double-protected and thus corresponds to protection class 2.
Item number
163.801
Solution
Connect the Power Cord to a working
electrical outlet or switch the device
from Night Mode
Fill Water Reservoir
Fill Water Reservoir
Clean Water Reservoir and let dry. Add
clean, fresh water
Exchange the aroma pad
Remove and reposition Water Reservoir
correctly on the Base
Fill Water Reservoir
Place device on a firm, level surface
Remove and reposition Water Reservoir
correctly on Base
Inspect attachment between Base and
Water Reservoir for debris or mineral
deposits and clean if required
Unplug device and restart
)
2
6