Activesync Communication - Honeywell Dolphin 6110 User Manual

Charging Terminal with USB Cable
Not only can you communicate between the terminal and the host using the Dolphin Charging/
Communication cable, but you can also trickle charge the terminal. To charge the battery using the USB
cable, select Start > Settings > Control Panel >Battery > USB charging.

ActiveSync Communication

To synchronize, ActiveSync 4.1 or higher must be installed and configured for the appropriate
communication type on the host workstation and the Dolphin terminal. Dolphin terminals ship with
ActiveSync already installed. Therefore, if ActiveSync is already installed on the host workstation, you just
need to connect the Dolphin terminal to the host workstation (via Dolphin peripheral) to initiate
communication.
Note: You can download the most current version of ActiveSync from www.microsoft.com.
When communicating via ActiveSync, your terminal is designed to be connected to the host workstation with a
Honeywell communication peripheral. We recommend use of Honeywell peripherals, power cables, and
power adapters. Use of any non-Honeywell peripherals, cables, or power adapters may cause damage not
covered by the warranty.
Communication Type
The Dolphin 6110 supports the following type of communication via ActiveSync through its
(see page 3-11) on the bottom panel:
USB
Hardware Requirements for Setup
• Dolphin communication peripheral
• Dolphin power cable
• USB Cable (for USB communication)
• ActiveSync v4.1 or higher installed on the host workstation
• Windows 98 Second Edition, Windows Me, Windows 2000, Windows NT (4.0 SP6 or higher),
Windows XP, Windows 7, or Windows 10 computer
The USB cable and hardware peripherals allow the Dolphin terminal to communicate with a
workstation through a USB port or to a network through a USB hub. The Dolphin terminal
supports high-speed USB communication (USB 2.0); maximum data transfer rate is 480
Mbps. The Dolphin terminal defaults to USB communication out of the box.
I/O Connector
6-3