Table of Contents
Advertisement
Getting started
Telephone base installation
Install the telephone base close to a telephone jack and a power outlet not
connected to a wall switch. The telephone base can be placed on a flat surface or
vertically mounted on the wall (page xx). For optimum range and better reception,
place the telephone base in a central and open location.
1. Plug the small end
of the power adapter
into the power jack
at the bottom of the
telephone base.
Telephone line cord
DSL filter
(Optional for DSL users,
see number four in the
note section, below.)
5. Plug the other end of
the telephone line cord into
a telephone jack.
NOTES:
1. Use only the power adapter supplied with this product or equivalent. To order a
replacement power adapter, visit our website at
1 (800) 222-3111.
or call
2. This power adapter is intended to be correctly oriented in a vertical or floor
mount position.
1 (866) 288-4268
In Canada, dial
6
2. Plug one end of the
telephone line cord
into the telephone jack
at the bottom of the
telephone base.
3. Route cords
through slots.
4. Plug the large
end of the power
a d a p t e r i n t o a n
electrical outlet not
connected to a wall
switch.
www.telephones.att.com
.
Advertisement
Table of Contents
