Installation - Watts IntelliFlow A2C-M1 Operating Instructions Manual

Installing the Watts Model A2-LS Leak Sensor
Description:
The Watts Model A2-LS Leak Sensor plugs into the receptacle
on the front panel of the Watts IntelliFlow
A2-WB-M1. The base of the sensor is placed on the floor close
to the washing machine. Upon detection of water at the sensor
the IntelliFlow ® immediately shuts off the water supply to the
washing machine hoses preventing catastrophic water damage.

Installation:

1. Insert the leak sensor contacts into the two holes on the top
of the sensor base until the plug comes to a stop (Figure 2).
2. Place the sensor base on the floor behind the washing machine
as close to the fill hoses as possible. Insure that the sensor
base is lying flat with all feet in contact with the floor surface.
3. Insert the leak sensor plug (Figure 1) into the leak sensor
receptacle on front panel (Figure 2).
Note: Some washing machine models include circuitry that
causes a slight current draw at all times. These models
when connected to the IntelliFlow
supply to be energized continuously (Yellow LED: ON). The
IntelliFlow can be reset by unplugging and reinstalling the
®
leak sensor.
Series A2C-M1 or
®
can cause the water
®
4
Figure 1
Sensor Plug
Figure 2
Sensor Contacts
Sensor Base