Table of Contents
Advertisement
2.4 Installation procedure
First the CVF4 is screwed flat on its mounting plate. In case the CVF4 is mounted on a solar tracker, the tracker has to be levelled first.
On our sun trackers the CVF4 is positioned such that the fan sticks out over the edge of the plate. This ensures the air inlet is
never blocked (see picture of the CVF4 on the SOLYS2 Sun Tracker on the next page). The locations of the CVF4 mounting holes
on the SOLYS2 top mounting plate are shown below.
CVF4 mounting holes
When using your own mounting plate, make sure the CVF4 is mounted in the same way with the fan sticking out. The CVF4
mounting holes size and distances are indicated in the drawing below.
Ø 7 mm (2x)
The CVF4 is mounted with the supplied 4 washers and 2 screws through mounting plates from 4 to 8 mm thick. The other 2 feet
are for stability but do not need screws.
12
Advertisement
Table of Contents
