Light Bulb Replacement; Fuse Replacement; Vehicle With A Discharged Battery; Transporting Vehicle - Cushman BELLHOP 2 Owner's Manual And Service Manual

OPERATION AND SERVICE INFORMATION
Read all of Manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings

LIGHT BULB REPLACEMENT

To reduce the possibility of premature bulb failure, do not
touch new bulbs with bare fingers. Use clean, dry tissue
or
paper towel to handle the glass portion of the bulb.
For vehicles equipped with lights mounted below cowl,
locate bulb socket on backside of light bar (Ref Fig. 11 on
page 10) and turn bulb socket a quarter turn counter-
clockwise to unlock and pull out bulb. Insert new bulb
(Ref. Capacities and Replacement Parts on page 24) and
rotate socket a quarter turn clockwise to secure.
To replace the tail and brake light bulb, remove hardware
securing lens and remove lens (Ref Fig. 12 on page 10).
Install replacement bulb (Ref. Capacities and Replace-
ment Parts on page 24).
To replace the tail and brake light bulb, roll the rubber
bezel from around the edge of the taillight and remove
lens. Install replacement bulb and replace lens.

FUSE REPLACEMENT

To replace fuses, locate the fuse block under the driver
side seat. Pull out old fuse and replace with a new auto-
motive type fuse. Headlight and taillight bulbs and fuses
are available from a local Distributor, an authorized
Branch or the Service Parts Department.
Headlights
Marker
Turn
Light
Signal
Light
Y
Ref Hdr 1
Fig. 11 Headlight, Turn Signal & Marker Light Bulb
Replacement
Page 10
Turn Signal
Marker
Light
Light
R G
Owner's Manual and Service Guide

VEHICLE WITH A DISCHARGED BATTERY

To reduce the possibility of severe injury or
death from inadvertent motion, do not attempt
to 'jump start' a vehicle.
The vehicle is equipped with a starter/generator and
does not idle. When starting the engine, the starter/gen-
erator functions as a starter and with the engine running,
it functions as a generator.
With the short running times associated with this kind of
vehicle, the generator is more than adequate to maintain
the battery charge level. The generator is not designed to
charge a discharged battery.
When engine starts, the clutches engage and cause
vehicle to move making 'jump starting' both dangerous
and impractical.
If the vehicle battery has become discharged, it must be
charged using a 12 volt charger that is rated at 10 amps
or less. Read and understand all instructions provided by
the manufacturer of the charger.
Ref Tlr 2
Fig. 12 Tail and Brake Light Bulb Replacement

TRANSPORTING VEHICLE

TOWING

This vehicle is not designed to be towed.
Roll Rubber
Bezel Away
From Body
Tail/Brake
Light
Rear
Fender