Hardware - Cushman BELLHOP 2 Owner's Manual And Service Manual

Read all of Manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
•
Reattach fuel line to tank and drive the vehicle for
several minutes to circulate the additive through
the carburetor.
•
While engine is still warm, change oil.
•
Clean body, chassis and engine of debris, mud,
chaff or grass.

HARDWARE

Periodically, the vehicle should be inspected for loose
fasteners. Fasteners should be tightened in accordance
installed are considered 'wet' and require approximately 80% of the torque required for 'dry' fasteners.
BOLT SIZE 1/4"
Grade 2
(5)
Grade 5
(8)
Grade 8
(8)
BOLT SIZE M4
Class 5.8
(2)
(Grade 2)
5.8
Class 8.8
(3)
8.8
(Grade 5)
Class 10.9
10.9 (4)
(Grade 8)
Ref Tsp 1
OPERATION AND SERVICE INFORMATION
ALL TORQUE FIGURES ARE IN FT. LBS. (Nm)
Unless otherwise noted in text, tighten all hardware in accordance with this chart.
This chart specifies 'lubricated' torque figures. Fasteners that are plated or lubricated when
5/16" 3/8"
4 8 15
(11) (20)
6 13 23
(18) (31)
6 18 35
(24) (47)
M5 M6
1 2 4
(3) (6)
2 4 7
(6) (10)
3 6 10
(8) (14)
Fig. 34 Torque Specifications and Bolt Grades
Owner's Manual and Service Guide
with the Torque Specifications table (Ref Fig. 34 on page
23).
Use care when tightening fasteners and refer to the
Technician's Repair and Service Manual for specific
torque values.
Generally, three grades of hardware are used in the vehi-
cle. Grade 5 hardware can be identified by the three
marks on the hexagonal head and grade 8 hardware is
identified by 6 marks on the head. Unmarked hardware is
Grade 2 (Ref Fig. 34 on page 23).
7/16" 1/2" 9/16"
24 35 55
(33) (47) (75)
35 55 80
(47) (75) (108)
55 80 110
(75) (108) (149)
M8 M10 M12
10 20 35
(14) (27) (47)
18 35 61
(24) (47) (83)
25 49 86
(34) (66) (117)
5/8" 3/4" 7/8"
75 130 125
(102) (176) (169)
110 200 320
(149) (271) (434)
170 280 460
(230) (380) (624)
M14
55
(76.4)
97
(131)
136
(184)
1"
190
(258)
480
(651)
680
(922)
Page 23