Advertisement
STEP 4: RADIO PROGRAMMING AND DEMONSTRATION
"DISC" should become a new source on the customer's radio within two full power cycles of the vehicle.
If the vehicle and radio do NOT accept programming:
1. Verify DIP switch setting from step 1.
2. With all doors shut and vehicle powered down, disconnect the negative side of the battery. (If equipped with an
Intelligent Battery Sensor (IBS), see dealership workshop manual.)
3. Leave disconnected for 5 minutes.
4. Once reconnected, power on vehicle and allow radio to fully power on.
5. Turn vehicle off, open and close driver door.
6. Allow 5 additional minutes for the vehicle to fully "go to sleep."
7. Turn vehicle on again and "DISC" should be populated under the SOURCES menu.
8. If no "DISC" icon has appeared, repeat steps 4-6 one additional time.
The 5000-8750 module MUST remain installed in the vehicle for continued operation of the add-on CD player.
For additional assistance, contact Brandmotion Technical Support at 1-734-619-1250 and select option 2 twice.
5000-8750 Instructions 02-22-17.docx
INSTALLATION INSTRUCTIONS
Page 9 of 9
GS
Advertisement
