Advertisement
STEP 3: RADIO REMOVAL AND WIRING INSTALLATION
IMPORTANT NOTE:
Make sure wiring is secured and cannot interfere with normal vehicle operation.
1. Use a plastic trim removal tool to remove the radio screen trim bezel (marked as "1" in the picture below) and
remove the electrical connectors. For 8.4-inch RA3 and RA4 radios, the screen can stay attached to the trim
bezel. For 5.0-inch RA2 radios, it is recommended to remove the radio from the trim bezel.
2.
For 8.4-inch RA3 and RA4 radios, proceed to remove the back end of the radio and disconnect the main 52-pin
connector.
3. Route wiring from the CD player and install T-harness behind radio. 5000-8750 module should be installed on
the T-harness at this point.
4. Reinstall radio, screen, and bezel in opposite order and ensure the added wiring and module is securely fastened
in the dashboard behind the radio.
5. Once install is finished, replace all panels and ensure cabling is ran in a way that will not pinch or damage wiring.
5000-8750 Instructions 02-22-17.docx
INSTALLATION INSTRUCTIONS
Page 8 of 9
GS
Advertisement
