Advertisement
INSTALLATION INSTRUCTIONS
5. Remove the change tray from the bin. This will no longer be used.
6. Cut out supplied template along black lines.
7. Unsnap plastic bin sides to reveal mounting screws, as pictured below:
8. Apply templates and tape into place.
9. Follow directions on templates to drill (2) 1/8" holes and (1) 1 ¼" hole.
10. Route wiring through 1 ¼" hole and plug into CD player. (This can also be done after installation of CD player.)
11. Install CD player in opening, aligning threaded stand-offs with new 1/8" holes.
12. Use screws removed from CD player in step 1 to secure CD player in place using 1/8" holes and threaded stand-
offs.
13. Reinstall bin sides, reinstall bin in dash and route wiring behind radio. (See step 3 for radio removal.)
14. Leave sufficient slack in wire to allow bin to open and close without pinching or stretching wire.
5000-8750 Instructions 02-22-17.docx
Page 6 of 9
GS
Advertisement
