ILX Lightwave OMH-6727B User Manual page 31

POWer:REFerence
POWer:REFerence?
PREselect:CHAN
PREselect:CHAN?
PREselect:SAVE
RANge
RANge?
RANge:AUTO
RANge:AUTO?
RATE
RATE?
SECURE
TERM
TERM?
TIME?
TIMER?
WAVE
WAVE?
WAVE:AUTO
WAVE:AUTO?
WAVE:MODE
WAVE:MODE?
WAVE:OFFSET
WAVE:OFFSET?
WAVE:REFerence
WAVE:REFerence?
ZERO
ZERO?
Table 3.1 Device-Dependent Commands valid with the OMH-6727B
4_03
C O M M A N D R E F E R E N C E
Sets the reference for ∆P measurements
2
None Returns the power reference level
1 Selects on of four preselected wavelengths
None Returns the preselected wavelength channel
being used
2 Sets one of the four preselected wavelengths
1 Sets the gain range (manual)
None Returns the gain range (auto/manual)
1 Sets the autoranging mode on or off
None Returns the status of the autoranging
1 Sets the measurement rate
None Returns the measurement rate string
1 Used by service personnel to access PUB
1 Sets the program message terminator
1 Returns the program message terminator
None Returns elapsed time since power up
None Returns elapsed time since last TIMER?
2 Sets the wavelength
None Returns the set wavelength
1 Sets the auto wavelength feature on or off
None Returns the status of auto wavelength
1 Sets the wavelength display units
None Returns the wavelength display units
2 Sets the wavelength offset
None Returns the wavelength offset
2 Sets the reference for
None Returns the wavelength reference point
None Starts the zeroing function
None Returns the status of the zeroing.
C H A P T E R
Error Messages
1
∆λ
OMH-6727B
3
1
17