Installing The Stabilizer Kit - Cisco 7609 Installing

Installing the Stabilizer Kit

Installing the Stabilizer Kit
Note
Note
Step 1
Step 2
Cisco 7609 Internet Router Installation Guide
3-10
The stabilizer kit is included only in the accessory kits for the Cisco 7609
Internet Router.
If you are not installing the Cisco 7609 Internet Router in a rack, you must install
stabilizer brackets to the bottom of the chassis. The stabilizer brackets reduce the
possibility that the freestanding chassis will tip over.
Open the stabilizer kit package and use the kit contents list in
that all parts are included.
Table 3-2 Stabilizer Kit Contents
Quantity Part Description
16 M4 Phillips countersunk-head screws
2 Stabilizer brackets
Have a second person available to perform this procedure.
To install the stabilizer brackets, perform these steps:
Have one person tilt and hold the chassis to one side.
With the chassis tilted, attach the stabilizer bracket to the side of the chassis with
the eight M4 screws as shown in
Chapter 3 Installing the Cisco 7609 Internet Router
Figure 3-5.
Table 3-2 to verify
Received
OL-5079-04