Cisco 7609 Installing page 17

Chapter 3 Installing the Cisco 7609 Internet Router
To connect a terminal using a Catalyst 5000 family Supervisor Engine III console
cable, perform these steps:
Place the console port mode switch in the out position.
Step 1
Connect to the port using the Supervisor Engine III cable and the appropriate
Step 2
adapter for the terminal connection.
Position the cable in the cable guide (if installed). Make sure there are no sharp
Step 3
bends in the cable.
Check the terminal documentation to determine the baud rate. The baud rate of
Step 4
the terminal must match the default baud rate (9600 baud) of the console port. Set
up the terminal as follows:
•
•
•
•
To connect a modem to the console port, perform these steps:
Place the console port mode switch in the in position.
Step 1
Connect to the port using the RJ-45-to-RJ-45 rollover cable and the
Step 2
RJ-45-to-DB-25 DCE adapter (labeled "Modem").
Position the cable in the cable guide (if installed). Make sure there are no sharp
Step 3
bends in the cable.
OL-5079-04
9600 baud
8 data bits
No parity
2 stop bits
Attaching the Interface Cables
Cisco 7609 Internet Router Installation Guide
3-17