Air Burners BurnBoss T22 Operating Manual page 18

Air Burners, Inc.
BurnBoss Series Air Curtain Burner (Kubota Z482-E3 Engine)
OPERATING MANUAL
HOW TO SET UP THE MACHINE
C) STARTING (Kubota Z482)
Turn the speed control knob clockwise to en-
sure engine speed is at idle.
Close battery disconnect switch located on
the battery terminal, if option is installed.
Battery Disconnect
If needed, turn key switch counterclockwise to (Optional)
the PREHEAT position for a few seconds.
Turn the key switch clockwise to the RUN po-
sition.
The gauges will register to confirm that power
is supplied to the panel.
Start the engine by turning the key switch all
the way clockwise to "START", then release
key switch, and warm up the engine at idle
speed of 1,000 RPM for 5 to 10 minutes.
Control Panel
Shut the engine down to prepare for loading
and lighting (see pages 16-18 for loading and
lighting instructions). The fan is direct drive,
so leaving the engine running during light-
ing will make it more difficult to light.
Tach
Once running, the engine speed may be var-
ied as required by turning the speed control
knob clockwise to decrease, counter clock-
Oil
Temp
wise to increase.
The maximum engine speed is governed to
provide the correct amount of air flow.
Hours
Fuel
Page 14 of 27
(Vers. 08.08.2017)