Air Burners BurnBoss T22 Operating Manual page 14

Air Burners, Inc.
BurnBoss Series Air Curtain Burner (Kubota Z482-E3 Engine)
OPERATING MANUAL
HOW TO TRANSPORT THE MACHINE
B) LOWERING THE FIREBOX FOR USE.
1) The FireBox must be on level ground.
2) The machine should be disconnected from the tow vehicle.
3) The front jack stand should be down and secure.
4) Battery switch (if equipped) must be on to operate hydraulic controls.
5) Raise the FireBox to release the load on the safety pins.
6) Remove the safety pins at each end of the FireBox.
7) Lower the FireBox until it contacts the ground.
8) Shovel dirt around the inside edges where the FireBox contacts the ground to pre-
vent heat and smoke from leaking out, especially behind the tires.
Hydraulic Oil
If you are operating in cold weather you may need to warm the hydraulic oil before use. In most cases
running the engine for 30 minutes will generate enough heat. If you still have difficulties operating the
hydraulic system you will need to change the oil to a colder spec oil. Your machine's hydraulic system
comes standard from the factory with Amsoil Synthetic hydraulic oil ISO32 (Amsoil P/N HVH05-EA). If
your machine will operate in cold temperatures or remain outside for long periods in cold temperatures
you will need to use a synthetic hydraulic oil such as Amsoil P/N HVG05-EA, ISO22. Your machine's
hydraulic system holds approximately 2.16 gallons (8.19 liters) of fluid.
Hydraulic Oil Tank
(Fill)
Hydraulic Oil Tank
(Drain)
Hydraulic Control
Diesel Fuel Fill
Safety Pins
Battery cut-off switch
(Optional)
Page 10 of 27
(Vers. 08.08.2017)