Adjusting The Nailing Depth - Makita DBN500 Instruction Manual

Nailing mode selection
1
3
014618
The tool has two different nailing modes. Select the
desired nailing by the mode selecting button. For more
detail, see the section "OPERATION".
Intermittent nailing (sequential mode)
This mode suits for driving a nail carefully and
accurately.
Continuous/ intermittent nailing (continuous mode)
When the tool is set to this mode, you can choose either
continuous or intermittent nailing by sequences of the
trigger operation.

Adjusting the nailing depth

WARNING:
Always make sure that your fingers are not placed
•
on the trigger, and the battery cartridge and nails
are removed.
A A
B B
014601
To get shallower depth, turn the adjuster to A direction
as shown in the figure. To get deeper depth, turn the
adjuster to B direction.
Do not turn the adjuster too much, or the adjuster may
get stuck.
Lighting up the lamp
CAUTION:
Do not look in the light or see the source of light
•
directly.
1. Mode selecting
2
button
2. Sequential
mode
3. Continuous
mode
1. Adjuster
1
3
1
014600
To turn on the lamp, pull the trigger or place the contact
element against the workpiece. Release the trigger or
contact element to turn it off.
The lamp goes out 10 seconds after releasing the
trigger or contact element from the workpiece.
NOTE:
Use a dry cloth to wipe the dirt off the lens of lamp.
•
Be careful not to scratch the lens of lamp, or it
may lower the illumination.
Even in the lamp lights up when the battery power
•
residual gets small, the nailer may not fire nails. In
this case, charge the battery cartridge.
ASSEMBLY
CAUTION:
Always make sure that your fingers are not placed
•
on the trigger, and the battery cartridge and nails
are removed before carrying out any work on the
nailer.
Loading or unloading the nails
CAUTION:
Always make sure that your fingers are not placed
•
on the trigger and the battery cartridge is removed
before loading nails.
Do not abruptly slide the slide door of the nailer
•
loaded with nails. Accidentally dropping nails
especially when working in high places may cause
personal injuries.
Load nails in the correct direction. Loading in
•
wrong direction may cause premature wear and
tear of the driver and damage of the other parts.
Do not use deformed connected nails. Use nails
•
specified in this manual. Using nails other than
those specified may cause nail jamming and
breakage of the nailer.
7
1. Lamp
2
2. Trigger
3. Driver guide
(contact
element)