Advertisement
CAUTION: Choose reset mode will modify all the parameter to the initial setting, please do it
carefully.
Auto Sleep
When hot air gun put on the holder, the temperature of hot air gun will start to decrease (Fig.14), and
the display will show " SLP" to indicate hot air gun is in sleep mode now. When the temperature is lower
than 100℃, the station will display as Fig.3. It will awake the rework station when hot air gun lift from
the holder.
Auto Cool-Off
After the rework station is turned off, the auto cool-off process leaves the blower on until the heating
element cool down to 100℃(Fig 15.), then rework station will shut off automatically.
CAUTION: Do not unplug the power plug when the auto cool off process is work on.
Do not touch the pin of plug to prevent electrical shock for human body.
Operation Instructions (SMD rework)
Remove SMD components (such as QFP, SOP, PLCC and so on)
1. Adjust air speed and hot air gun temperature to desired level
2. Slip the pick-up puller (optional part) under the component lead. (Fig. 16) If the component
width does not match the size of the pick-up, adjust the width of the pick-up by squeezing
the wire. Use tweezers to remove PLCC or small components such as chip resistors,
desolder, etc.
3. Hold the hot air gun above the SMD components (do not touch the components directly),
allowing the hot air to melt the solder. Be careful not to touch the leads of the components
with nozzle.
4. When the soldering tin is melted, remove the SMD components by lifting the pick-up puller
(Fig. 17)
Fig.14
Fig.15
Fig. 16
7
Advertisement
