TC Electronic Konnekt Live User Manual page 30

SYSTEM SETTINGS
Example 2: Konnekt Jitter Rejection
Optical S/PDIF
power MIDI s/pdif line outputs line inputs
in out ch3(L) ch1|main L ch3(L) ch1(L)
Nickname
DI
DI DO ch4(R) ch2|main R ch4(R) ch2(R) "My Konnekt"
bus powered
firewire DO
adat|optical
FIREWIRE (IEEE 1394)
power MIDI s/pdif line outputs line inputs
ch3(L) ch1|main L ch3(L) ch1(L) Nickname
in out
DI
"Peter's Konnekt"
DI DO ch4(R) ch2|main R ch4(R) ch2(R)
bus powered
firewire DO
adat|optical
COAX S/PDIF I/O
PAGE PRE DELAY DECAY HI DECAY PROGRAM CONTROL
0 OVERLOAD
POWER
96 kHz HOME RECALL
88.2 kHz
48 kHz
STORE
HIGH DEFINITION REVERB 44.1 kHz
DIGITAL IN
MIDI
WIZARD
L dB R EDITED
In this setup we have a CD player in the system. In
therms of digital clicking a CD player is uncontrollable
and can thus only act as master.
Thanks to the DICE II FireWire chip with integrated
JetPLL jitter rejection technology, Konnekt Live provides a
very high clock quality. Not only does Konnekt provide a
high quality clock but the excellent jitter-rejection
facilities will clean up a digital signal from an external
source.
• The CD player is connected to "My Konnekt" via
optical S/PDIF.
• "My Konnekt" is selected as Clock Master on the
System Settings page and Sync Source is set to
Optical S/PDIF.
28
CD Player
R4000
ENTER I/O
UTILITY
BYPASS
•
• The R4000 is connected to the other Konnekt in the
setup (Peter's Konnekt) and it is set to slave to
"external".
4 Sample Rate
If Sync Source is set to "Internal", the sample rate
must be set. The options are:
44.1 kHz
48 kHz
88.2 kHz
96 kHz
176.4 kHz
192 kHz
The sample rate is typically set by your host
application (e.g. Cubase LE). If you e.g. play a 44.1
kHz project the sample rate automatically shifts to
44.1 kHz. If you later load and play a 48kHz song,
the sample rate shifts to 48 kHz.
Though Konnekt receives information about the
sample rate it still provides the actual digital clock.
5 Lock Status
Various lock status indications can be given:
Internal Lock
Indicates that the system is locked to the Konnekt
unit set as clock master.
External Lock
Indicates that the system is locked to an external
digital device connected to the Konnekt set as clock
master.