Cordless Telephone Operation - BellSouth GH9640 Owner's Manual

Cordless Telephone Operation

NOTE:
1. The Call Timer will start to count once you press the
2. The LCD Screen emits light for 5 seconds every time you press any buttons on the HANDSET.
3. When "CALLS" appears on the LCD Screen, it means that the HANDSET is off-hook (connected
to the telephone line).
Placing Calls
talk
1. Press the button, the Call Timer starts to
count. The HANDSET LCD Screen will display
"Calls", and "Talking", and the BASE UNIT IN
USE LED indicator will light up.
2. Listen for a dial tone.
3. Dial the phone number.
4. When you have finished with your call, press the
talk
button again or place the HANDSET on
the BASE UNIT.
OR
1. Dial the phone number.
7
2. Press and hold down the DIAL 7
10
1+ #
0
OPER
DIAL 10 or the DIAL 1+
The BASE UNIT IN USE LED indicator will light
up.
3. When you have finished with your call, press the
talk
button again or place the HANDSET on
the BASE UNIT.
talk
button.
Minutes
CALLS
Seconds
MIN SEC
00 1 14
Channel
or the
button.
Cordless Telephone Operation
Call Transfer
1. When User expect to transfer a call made or receive from one handset to another, just simply
press the call transfer key & display will shows "EXT. NUMBER", then press the handset
number to execute the number to execute the transfer.
2. If the call transferred party does not pick up the call within 20 seconds the call will be bounced
back to initiate party, If initiate party do not pick up the transferred call within 20 seconds. The
Tel Line will be disconnected automatically.
Headset Feature
Your telephone can utilize a headset (not included) to be
connected to your HANDSET for you to enjoy hands-free
communication. Insert the small plug at the end of the
headset into the HEADSET JACK at the right side of the
HANDSET. Follow the procedures discussed in "Receiving
Calls" and "Placing Calls" to receive and place a call.
NOTE: When you plug the headset plug into the HEADSET
JACK it automatically mutes the MICROPPHONE
and SPEAKER of the HEADSET. Unplug the
headset to return the HANDSET to normal use.
Headsets are available at most retail outlets that sell
telephone equipment. The HEADSET JACK is compatible
with 2.5 mm headset plugs only.
Redial Feature
1. If you get a busy tone, press the talk
the HEADSET on the BASE UNIT to hang up.
2. Later, press the talk button again.
3. Listen for a dial tone.
Save/pause
redial
4. Press the button. This will automatically redial
the last telephone number you called in TALK mode.
5. When you have finished with your call, press the
button again (the BASE UNIT IN USE LED
talk
indicator will return off) or place the HEADSET on the
BASE UNIT.
NOTE:
If you are far away from the BASE UNIT, the HEADSET emits "beep" sounds to warn you that the
background noise level is too high for proper communication between the HANDSET and the BASE
UNIT. When you hear this sound, you should move closer to the BASE UNIT to reduce the noise
level. Otherwise, the call will automatically cut off.
button or place