Table of Contents
Advertisement
RDL-3000 FAMILY
3
Module Installation and Service
3.1 Installation into a Final Product
The modules must be installed only by trained professional technicians authorized by
Redline or its agents. The module must be installed only into an approved enclosure
(see Conditions of Use) and only at an approved manufacturing facility or service depot.
Redline shall retain complete control over the final installation of the module and will
ensure compliance of the end product to all applicable regulations. The module must be
installed only into an approved enclosure (see Conditions of Use) and only at an
approved manufacturing facility or service depot.
Redline licensing of the modular transmitter includes monitoring to ensure compliance in
the operation and use of the module as expressly specified within this manual. This
includes restrictions against modification of the module hardware, approval of the final
enclosure, operational restrictions for installers and end-users, and approval of antennas
provided for use with the product.
Operation of the final product requires the 'key' be controlled exclusively by the
manufacturer. The 'key' must be unique to each module and must be installed and
activated before the radio will operate. The key must contain sufficient security features
to the professional installer and operator can not decode, modify, substitute, or
otherwise circumvent the operational restrictions imposed by the 'key'.
The software 'key' must limit the transmit power, operating frequency range, and channel
bandwidth per the regulator domain governing the location where the radio will be
deployed. The operator does not have the option to select the country or regulatory
region of operation.
The software 'key' must limit the mode of operation as a master or client. The client
mode is 'passive listener' and while in this mode the module can not initiate any
transmission without first receiving and decoding a valid authorization message from the
master. A module with a key for client operation can not be changed by the installer to
enable master mode operation.
Redline will review all final products for compliance to regulatory restrictions.
The manufacturer must meet all labeling described in section 2.3.
3.2 Module Servicing
The modules are not intended to be field serviceable, and contains no field serviceable
or field replaceable parts. The module must be serviced only at an approved
manufacturing facility or service depot.
Warning:
Electrostatic Discharge (ESD) must be avoided to prevent damaging or destroying the
module. The module must always be store in an anti-static container/bag prior to
installation and following removal from the product for servicing. Observe ESD
precautions when handling the module.
3.3 Professional Installation
Devices containing the module require professional installation. It is the responsibility
of the installer to understand the product operation by attending training as required,
reading and understanding the product documentation, and ensuring that all building,
safety and regulatory codes are met and the installation is complete and secure.
70-00184-06-00a
RDL-3000-RMD PRODUCT MANUAL
The modules are susceptible to damage from electrostatic charge.
Proprietary Redline Communications © 2013
Page
8
of 20
December 9, 2013
Advertisement
Table of Contents
