Unpacking; Mounting Guidelines - Briggs & Stratton Symphony II Installation & Operator's Manual

Power management system
Table of Contents

Advertisement

Available languages

Available languages

Unpacking

Delivery Inspection
After opening the carton, carefully inspect the contents for
any damage that may have occurred during shipment.
IMPORTANT: If loss or damage is noted at time of delivery,
have the person(s) making delivery note all damage on the
freight bill and affix his signature under the consignor's
memo of loss or damage. If loss or damage is noted after
delivery, contact the carrier for claim procedures. Missing or
damaged parts are not warranted.
Shipment Contents
• Power manager (1)
• Installation and operator's manual (1)
• Fuse (2)
• Fuse holder (1)
• Current transformer (2)
• Decal (1)
• Screw (4)
• Compact terminal block (4)
• 1/4" single female lug (4)
• 1/4" single male, single female lug (2)
Contactor
Hot
water
heater
Branch circuits
6

Mounting Guidelines

The system circuitry is enclosed in a NEMA Type 3R
enclosure suitable for indoor/outdoor use. Guidelines for
mounting the enclosure include:
• Install enclosure on a firm, sturdy supporting structure.
• The enclosure must be installed with minimum NEMA
3R hardware for conduit connections.
• Level and plumb the enclosure. This can be done
by placing washers between the enclosure and the
mounting surface.
NOTE: UL mandates that "Class 2 field wiring shall be
contained in the upper (terminal block) portion of the
enclosure. High voltage field wiring shall be routed in a
manner to maintain separation (of 6 inch) to Class 2 wiring
(including PCB board)."
• Never install the device where any corrosive substance
might drip onto the enclosure.
• Protect the device at all times against excessive
moisture, dust, dirt, lint, construction grit and
corrosive vapors.
A typical installation is depicted below. It is best if the
enclosure is mounted near the main breaker panel, either
inside or outside the building. Discuss layout suggestions/
changes with the owner before beginning system installation.
Main
breaker
panel
Power
manager
Service
disconnect
Watt -
hourmeter
Transfer
switch
Generator
Air
conditioner
Disconnect
switch
BRIGGSandSTRATTON.COM

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents