Damper Motor And Damper Switch Removal; Heater Duct Left Assembly, Heater Duct Upper Assembly And Convection Duct Assembly - Electrolux ICON E30SO75ESS Technical & Service Manual

Component Teardown
Damper Motor And Damper Switch
Removal
1. Disconnect power supply cord and remove outer
case.
2. Open the oven door and block it open.
3. Discharge the high voltage capacitor.
To discharge the high voltage capacitor, wait for 60
seconds and then short-circuit the connection of
the high-voltage capacitor (that is the connecting
lead of the high-voltage rectifier) against the
chassis with the use of an insulated screwdriver.
4. Remove the back plate from the oven.
5. Remove the one (1) screw securing the right chassis
support to the oven cavity front plate.
6. Disconnect the wire leads from the damper motor.
7. Remove the two (2) screws securing the damper
motor to the motor mounting angle.
8. Now, the damper motor is free.
9. Disconnect the wire leads from the damper switch.
10. Remove the two (2) screws securing the motor
mounting angle to the damper duct assembly.
11. Remove the one (1) screw securing the damper
switch to the motor mounting angle.
12. Now, the damper switch is free.
Heater Duct Left Assembly, Heater
Duct Upper Assembly And
Convection Duct Assembly Removal
1. Disconnect power supply cord and remove outer
case.
2. Open the oven door and block it open.
3. Discharge the high voltage capacitor.
To discharge the high voltage capacitor, wait for 60
seconds and then short-circuit the connection of
the high-voltage capacitor (that is the connecting
lead of the high-voltage rectifier) against the
chassis with the use of an insulated screwdriver.
4. Remove the back plate from the oven.
5. Remove the door assembly from the oven, referring
to "DOOR REPLACEMENT", and remove the door
springs, the door cam right and the door cam left.
6. Remove the power transformer, magnetron,
magnetron separator, high voltage capacitor
assembly, fan motor (power transformer side) with
fan mounting angle, and fan motor (magnetron side),
referring to their removal procedures.
7. Disconnect the wire leads from all electrical parts
except for the turntable motor, monitor switch,
secondary interlock switch and door sensing switch.
8. Remove the two (2) screws securing the latch hook
right and latch hook left from the oven cavity front
plate.
9. Remove the two (2) screws securing the right and left
chassis supports to the oven cavity front plate.
10. Remove the two (2) screws securing the exhaust duct
to the oven cavity and remove from unit.
11. Remove the one (1) screw securing the damper duct
assembly to the oven cavity from inside of the oven
cavity.
12. Remove the two (2) screws securing the damper duct
assembly to the thermal cover upper and the wave-
guide.
13. Remove the damper duct assembly from the oven.
14. Remove the two (2) screws securing the separator
left to the thermal cover upper and remove from unit.
15. Disconnect the connector of the touch control
transformer from the power unit.
16. Remove the one (1) screw securing the touch control
transformer to the bottom plate and remove from unit.
4-6