Convection Motor Removal; Damper Assembly Removal - Electrolux E30MO65GSSB Technical & Service Manual

Component Teardown

Convection Motor Removal

1. Disconnect oven from power supply and remove
outer case.
2. Discharge the high voltage capacitor.
To discharge the high voltage capacitor, wait for 60
seconds and then short-circuit the connection of
the high-voltage capacitor (that is the connecting
lead of the high-voltage rectifier) against the
chassis with the use of an insulated screwdriver.
3. Disconnect wire leads from the convection motor.
Remove the convection fan belt.
4. Remove two (2) screws holding the convection motor
mounting angle to the heater duct and base cabinet.
5. Take out the convection motor assembly from the
unit. The convection motor assembly is now free.
6. Remove two (2) screws and nuts holding the motor to
mounting angle.
7. Remove pulley (M) from the motor shaft. Convection
motor is now free.
Turntable Motor Removal
1. Disconnect the oven from power supply.
Remove the turntable tray and the turntable support
out of the oven cavity.
2. Turn the oven upside down and remove one (1)
screw holding the turntable motor cover to the base
plate and take off the turntable motor cover.
3. Disconnect wire lead from the turntable motor.
4. Remove the two (2) screws holding the turntable
motor and coupling mounting plate to the oven cavity
bottom.
5. Turntable motor, Coupling mounting plate and
Thermal protection plate bottom will be free.

Damper Assembly Removal

1. Disconnect oven from power supply and remove
outer case.
2. Discharge the high voltage capacitor.
To discharge the high voltage capacitor, wait for 60
seconds and then short-circuit the connection of
the high-voltage capacitor (that is the connecting
lead of the high-voltage rectifier) against the
chassis with the use of an insulated screwdriver.
3. Disconnect wire leads from damper motor and
damper switch.
4. Remove two (2) oven side screws holding damper
motor angle to thermal protection plate (right).
5. Damper assembly is free.
6. Remove one (1) screw holding damper motor to
damper motor angle and one (1) screw holding
damper switch to damper motor angle.
7. Damper motor and switch are free.
Heater Unit Assembly Removal
THERMISTOR REMOVAL
1. Disconnect oven from power supply and remove
outer case.
2. Discharge high voltage capacitor.
To discharge the high voltage capacitor, wait for 60
seconds and then short-circuit the connection of
the high-voltage capacitor (that is the connecting
lead of the high-voltage rectifier) against the
chassis with the use of an insulated screwdriver.
3. Disconnect wire leads from thermistor. Remove two
(2) screws from thermistor.
4. Disconnect wire leads from convection motor, thermal
cut-out and heater element.
5. Remove nine (9) screws holding heater duct to the
oven cavity.
6. Remove two (2) screws holding heater duct to base
cabinet. Release two (2) snap bands holding wire
harness to the thermal cover (convection).
7. The heater unit is now free.
4-4