Side Heating Element Removal; Turntable Motor Removal - Electrolux ICON E30SO75ESS Technical & Service Manual

18. Remove the two (2) screws securing the PWB
mounting angle to the bottom plate.
19. Remove the PWB mounting angle with the power unit
from the bottom plate.
20. Remove the three (3) screws securing the thermal
cover left to the heater duct left.
21. Remove the one (1) screw securing the thermal
cover left to the thermal cover upper.
22. Straighten the three (3) tabs holding the thermal
cover left to the oven cavity, and remove the thermal
cover left and the thermal insulation left from the
oven cavity.
23. Remove the two (2) screws securing the thermal
cover upper to the heater duct upper.
24. Straighten the four (4) tabs holding the thermal cover
upper to the oven cavity, and remove the thermal
cover upper and the thermal insulation upper from
the oven cavity.
25. Straighten the two (2) tabs holding the thermal
insulation upper, and remove it.
26. Remove the fourteen (14) screws securing the heater
duct left to the oven cavity and the convection duct.
27. Remove the heater duct left assembly from the oven
cavity.
28. Now, the heater duct left assembly is free.
29. Remove the two (2) screws securing the convection
motor mounting angle to the bottom plate from under
the bottom plate.
30. Remove the thirteen (13) screws securing the
convection duct to the oven cavity and the heater
duct upper.
31. Remove the convection duct assembly from the oven
cavity.
32. Now, the convection duct assembly is free.
33. Remove the nine (9) screws securing the heater duct
upper to the oven cavity.
34. Remove the heater duct upper from the oven cavity.
35. Now, the heater duct upper assembly is free.
Component Teardown

Side Heating Element Removal

1. Disconnect power supply cord and remove outer
case.
2. Open the oven door and block it open.
3. Discharge the high voltage capacitor.
To discharge the high voltage capacitor, wait for 60
seconds and then short-circuit the connection of
the high-voltage capacitor (that is the connecting
lead of the high-voltage rectifier) against the
chassis with the use of an insulated screwdriver.
4. Remove the back plate from the oven.
5. Remove the heater duct left assembly from the oven.
6. Remove one (1) screw securing the heater mounting
angle A to the heater duct upper.
7. Remove the two (2) nuts securing the top heating
element to the heater duct upper.
8. Now, the top heating element is free.

Turntable Motor Removal

1. Disconnect the power supply cord.
2. Wait for 60 seconds to discharge the high voltage
capacitor.
3. Remove the turntable tray and the turntable support
from the oven cavity.
4. Lay the oven on its backside.
5. Remove the turntable motor cover by snipping off the
material in four corners.
6. Where the corners have been snipped off, bend
corner areas flat. No sharp edges must be evident
after removal of the turntable motor.
7. Disconnect the wire leads from the turntable motor.
8. Remove the one (1) screw securing the turntable
motor to the oven cavity bottom plate.
9. Now, the turntable motor is free.
10. After replacement, use the one (1) screw to fit the
turntable motor cover.
4-7