Air Filter; Fuel Tank Filter; Fuel Extension Filter - ALDI Workzone Titanium+ 62007 User Manual

Maintenance

Air Filter

It is very important to maintain an air filter (18) in proper condition. Damage to
the generator may arise if the filter has:
• Improperly been serviced.
• Dirt and other foreign elements adhering to the filter due to improper
installation and engine wear.
It is recommended the air filter (18) is cleaned every 50 hours (every 10 hours
under dusty conditions).
ALWAYS keep the filter clean at all times.
WARNING: Ensure the engine is switched off while undertaking this task.
1. Remove the air filter cover (17) on the side of the generator using the
supplied screwdriver (31) by removing (unscrewing) the two screws on the
face of the cover, in an anti-clockwise direction (Fig AA).
2. Remove the air filter (18) (Fig AB).
3. Wash the air filter (18) in hot soapy water and allow to dry.
4. Lubricate the air filter (18) using a small amount of engine oil (SAE 10W-30).
5. Thoroughly squeeze the air filter (18) removing any excess oil.
6. Replace the air filter (18).
7. Secure the air filter cover (17) back on to the side panel of the air filter
housing using the supplied screwdriver (31) by screwing back in the two
screws in a clockwise direction until secure.
IMPORTANT. Never run the engine without the air filter element in place.
CAUTION: Never use fuel or low burning paint solvents to clean the air filter
(18). A fire or explosion could result.
CAUTION: Ensure the air filter (18) is dry before re fitting.
Replacement air filters are available from https://help.tools/ or by calling
Customer Service on
1800 909 909. AA.
30
e-mail: help@powertoolsupport.com
MODEL: №. EP2800i • 09/2018 • 62007
Digital Inverter Generator with Pure Sine Wave
AB.
LOOSEN
TIGHTEN
AFTER SALES SUPPORT
1800 909 909
Digital Inverter Generator with Pure Sine Wave
Fuel Tank Inlet Filter
1. Turn the fuel tap/ lever (23) to the 'off' position (Fig AC).
3. The fuel tank inlet filter (24) is located directly under the fuel tank cap
4. Remove the fuel tank inlet filter (24) (Fig AE) and wash thoroughly
5. Re-assemble by putting the fuel tank inlet filter (24) back, and then
AC.

Fuel extension filter

A small fuel extension filter (22) has been fitted to the inlet side of the fuel
lever tap (23), inside the tank. This fuel extension filter (22) prevents any dirt
in the fuel from entering the fuel system. The procedure for removing this
filter is as per follows:
NOTE: the following procedure should be performed in a well ventilated
area, with no naked flames, sparks, or cigarettes. Safety glasses should also
be worn and both the engine on/off switch (2), and the 240Va.c Outlet
power on/off switch (1) need to be in the OFF position.
AFTER SALES SUPPORT
(toll free) (toll free)
WARNING: Ensure the engine is switched off while undertaking
this task.
(27) and protects impurities entering the fuel tank (26) during refuelling.
Remove the fuel tank cap (27) by turning in an anti-clockwise direction
(Fig AD).
in petrol.
securing the fuel tank cap (27) in a clockwise direction until firmly
secured.
AD.
OFF
ON
1800 909 909
Maintenance
AE.
31
e-mail: help@powertoolsupport.com
MODEL: №. EP2800i • 09/2018 • 62007