Component Description; Duplexer; Uplink Amplifier; Watt Downlink Power Amplifier - Dekolink MW-FBDA-PCS-xxx-50W Installation And Operation Instruction Manual

Fiberlink bi-directional amplifier
Hide thumbs Also See for MW-FBDA-PCS-xxx-50W:
Table of Contents

Advertisement

2. COMPONENTS DESCRIPTION:

2.1 DUPLEXER

The duplexer serves to frequency separate uplink signals from downlink signals. The
duplexer has sharp out of band attenuation for better isolation between the receiving
and transmitting paths and for better rejection of interfering signal in the air.
2.2 UPLINK PRE-AMPLIFIER
The uplink pre-amplifier is a low noise, 45dB gain unit. The amplifier contains AGC
control circuitry. When a high power signal is received the automatic level control
detects it and reduces the gain so that the output power of the amplifier is constant.
The AGC function limits the signal at the Fiberoptic transmitter input when high power
signals are received while keeping high gain when low power signals are received.
The LED on the amplifier illuminates when the power output of the amplifier exceeds
the AGC power set limit (when the AGC is either ON or OFF).
The Switch on the RF amplifier enables the AGC function. If the AGC is disabled then
the amplifier gives maximum gain for any input.
The AGC level is factory set to 0 dBm and AGC is set to ON, to prevent high power
damage at the Rfiber+ input.

2.3 50 WATT DOWNLINK POWER AMPLIFIER

This is the downlink power amplifier. It can drive 40 dBm composite power to the
mobile antenna. A thermostat attached to this amplifier turns on TEMP alarm when the
temperature exceeds 80° C. This amplifier has AGC circuitry that can be turned on to
limit transmitted power. The AGC switch is located on the power connection unit.

2.4 Fiberoptic to RF transceiver

TM
The RFiber+
product is a transceiver that includes a transmitter and receiver unit.
The transmitter converts the RF signals into light wave signals, which are then sent
over fiberoptic cables. The receiver converts light wave signals back to RF
The model in use is a wide band product in the 0.08-2 GHz frequency range.
Rev1
12/03
Dekolink WIRELESS Ltd.
16 Bazel St. Qiryat-Arieh Petah-Tikva, Israel, 49510
Tel- 972-3-9180-180 Fax-972-3-
e-mail:
marketing@dekolink.com
9180
-
190
web
www.dekolink.com
Page 5 of 17

Advertisement

Table of Contents
loading

Table of Contents