Table of Contents
Advertisement
Section 3 - Configuration
Depending on your Internet Service Provider, you may need to configure the PPPoE settings in order to connect to the Internet.
You may need to contact your ISP for this information. Click Save when you are done.
Profile Name:
Enter a custom name for this profile.
Username:
Enter the username assigned by your ISP.
Password:
Enter the password assigned by your ISP.
Advanced Settings
Address Mode:
Select Static IP if your ISP assigned you the IP address,
subnet mask, gateway, and DNS Server addresses.
Otherwise, select Dynamic.
Service Name:
Enter the ISP Service Name (optional).
Reconnect Mode:
Select either Always-on, On-Demand, or Manual.
Primary
Enter the Primary DNS Server Address.
DNS Address:
Secondary
Enter the Secondary DNS Server Address.
DNS Address:
MTU:
Maximum transmission Unit - you may need to change
the MTU for optimal performance with your specific ISP.
1492 is the default MTU.
Note: If you are using a PPPoE connection, you will need to
remove or disable any PPPoE client software running on your
computers.
D-Link DIR-508L User Manual
xDSL Broadband (PPPoE)
28
Advertisement
Table of Contents
