Feed the two conductor cable (4) into the union nut and retighten the union nut.
The external diameter must be 0.2" to 0.4".
Connect the two conductor cable to the screw terminals on the sensor head
marked (+) and (–). Observe the proper polarity.
Configuration of reference points if necessary (see section 6.1)
Screw the sensor head cap (1) back on.
The ground connector on the underside of the sensor head can be used for grounding or
equipotential bonding.
Protect the sensor head against the ingress of water. An external
cable diameter of 0.2" to 0.4" mm ensures reliable sealing of the
cable entry. Make sure that the cable gland is screwed tight, and
close the sensor head cap firmly.
XT-1000
Page 13/19