Maintenance & Cleaning - GE Evolve Installation Manual

• NOTE: Verify that dimming voltage is correct by
comparing it to the product nameplate and make
sure the electrical connection and separation of
dimming and branch circuit conductors comply with
national electrical code and applicable local electrical
codes.
5
OCCUPANCY SENSOR (optional)
• The programmable occupancy sensor is shipped with
a default program which may be modified using the
WattStopper® FSIR-100 wireless IR configuration tool
(sold separately).
• The FSIR-100 includes a complete set of instructions
to create and save alternative program configurations
to quickly apply to multiple fixtures.
These instructions do not purport to cover all details or variations in equipment nor to provide for every possible contingency to be met in
connection with installation, operation or maintenance. Should further information be desired or should particular problems arise which are not
covered sufficiently for the purchaser's purposes, the matter should be referred to GE Lighting.
g
GE Lighting • 1-888-MY-GE-LED
GE Lighting is a subsidiary of the General Electric Company. Evolve and the GE brand and logo are trademarks of the General Electric Company.
© 2013 GE Lighting. Information provided is subject to change without notice. All values are design or typical values when measured under laboratory conditions.
6
MAINTENANCE / CLEANING
• To maintain the highest optical efficiency, occasional
cleaning of the outer lens surface may be needed,
with frequency dependent on local conditions.
• Use a mild soap or detergent, which is essentially
neutral pH (pH approximately 6 to 8), nonabrasive,
and which contains no chlorinated or aromatic
hydrocarbons.
• Wash thoroughly, using a soft cloth.
• Rinse with clean, cold water and wipe dry.
• www.gelighting.com
(1 - 888 - 69 - 43 - 533)
35-201578-178 (Rev 01/09/18)
English