Setup Procedure; Setting The Time - BIOS WEATHER WEATHER CUBE Instruction Manual

2.0 Setup Procedure

1. Insert the USB adapter into the Weather Cube, you can then plug the USB adapter into a
USB port. Or you can power the Weather Cube with 3 x AAA batteries.
2. The Weather Cube will go through a sequence of numbers and then will beep once and
display the TIME.
3. The Weather Cube will automatically be set to display the different screens in the following
sequence: TIME (10 seconds) – DATE (2 seconds) – INDOOR TEMPERATURE (7
seconds) – OUTDOOR TEMPERATURE (7 seconds).

3.0 Setting the Time

1. When the TIME is displayed on the Weather Cube, press and hold the SET button.
NOTE: If the Weather Cube is not displaying the TIME, press the SET button to go
through the different screens until TIME appears.
2. 12/24 hour will flash, press the UP or DOWN button to select the hour format. Once
selected, press the SET button to confirm.
3. Next the hour digits will flash, press the UP or DOWN button to select the hour digits.
Once selected, press the SET button to confirm. Follow the same steps to set the minute
digits. Once confirmed, the Weather Cube will go back to normal mode.
9 00
AM
PM indicator
5 00
PM