Related Manuals for BIOS WEATHER 386BC
Summary of Contents for BIOS WEATHER 386BC
- Page 1 Wireless / Sans fil Instruction Manual Mode d’emploi Year Canada’s Source for Weather Instruments Since 1934 Source canadienne pour les instruments météorologiques depuis 1934 Colour Weather Station couleur Station météorologique...
- Page 2 Colour Weather Station Monitor Front: Monitor Back: A. Date and Time 1. SET Button B. Outdoor Temperature 2. ALARM Button C. Outdoor Humidity / CF Button D. Forecast Icon / CH Button E. Barometric Pressure 5. Battery Compartment Moon Phase 6.
-
Page 3: Troubleshooting
If communication between the outdoor sensor and monitor is successful the RF icon will show 1.0 Care of the Device maximum signal strength. If communication failed or signal is lost for more than 1 hour, the RF • Avoid exposing units to extreme temperatures or severe shock. icon will flash and display as “... - Page 4 a limited ability to forecast for the multitude of conditions it will encounter. It provides NOTE: The temperature signal travels in a straight line from the remote sensor to the monitor. a general forecast of weather changes in the same way a wall barometer forecasts changes in The signal will not curve around an object.
- Page 5 ±5% RH (between 30% RH and 80% RH) Accuracy ±8% RH (between 20% RH and 29% RH, 80% RH and 99% RH) Temperature & Humidity Checking Interval Monitor 30 seconds Remote Sensor 1 minute Power Source Monitor 3 x AAA batteries, 1.5V or AC adapter 2 x AA batteries, 1.5V (using lithium batteries during the cold months Remote Sensor is recommended)
Need help?
Do you have a question about the 386BC and is the answer not in the manual?
Questions and answers
how do i make my humidity read? It has said 20% for 2 years. I got another meter right beside it and reads 32%
To fix the humidity reading stuck at 20% on your BIOS WEATHER 386BC:
1. Press the CH button on the monitor to select the remote sensor channel you want to reset.
2. Press and hold the CH button to reset the outdoor temperature and humidity for that channel.
3. The display will show dashes (--.-°C and --%) and update after a few minutes.
If the issue persists, check the remote sensor batteries and ensure it is placed in a suitable location away from extreme conditions.
This answer is automatically generated
cannot get signal from outside remote Replaced the batteries, tried on 1,2,3, but get no readings anywhere
To fix the signal issue with the BIOS WEATHER 386BC remote after replacing the batteries, follow these steps:
1. Ensure all batteries are fresh and correctly inserted in both the monitor and remote sensor.
2. Move the CH slide switch on the back of the remote sensor to channel 1.
3. Make sure the transmission indication LED on the remote sensor is on.
4. Avoid placing the monitor near metal window frames or other electronic devices using the 433MHz frequency (e.g., headphones, speakers, doorbells, home security systems).
5. Wait for interference to stop; the temperature reading will resume once the interference ends.
If communication is successful, the RF icon on the monitor will show full signal strength. If not, the RF icon will flash.
This answer is automatically generated
Comment enlever la sonnerie d alarme
To turn off the alarm sound on the BIOS WEATHER 386BC, press any button except the SZN/LIGHT button when the alarm sounds.
This answer is automatically generated