Advertisement
There are 2 (and only 2) positions to fit any S-Box™ unit:
Either: A - Surface-mounted
Or: B - 'Inset' at -20mm (13/16") below surface.
A - SURFACE MOUNT
This simplest installation method is to insert it straight into a cut-out hole
The fitted collar sits neatly on the worktop surface. Its own weight will keep it there. Please do not use any
adhesive or sealant.
OPTION 1
In either of these surface-mount methods, it is also possible to 'personalise' the unit, by replacing the
steel top with a piece of matching material to the work top if required.
Maximum thickness of any material is 12.5mm (
with that new material. Then please follow counterbalance "re-weight" instructions shown later in this
guide.
B - 'INSET' or REBATED – The Unique Custom ("chameleon") Installation)
This method involves the installation of the unit at exactly 20mm (13/16") below the Counter-top surface
so that the product can be fully disguised into its location with a custom top that matches its surroundings.
This is known as an "Inset" or rebated method. The maximum thickness of this custom top is 12.5mm (
In worktop materials of 30mm (1+ 3/16") thickness and above, the installation is achieved by sitting the
collar on a rebate shelf within the material.
For materials of 20mm (7/16") thickness, installation is achieved by sitting the collar on a "false" rebate,
created by using a second slave material below it.
30 mm +
(1+3/16")
OPTION 3
NB. If Worktop material is only 12.5mm (1/2") thick, it will need to be built up
to 1+1/16" or more, to be thick enough to cut a rebate at 13/16" depth.
(A shallow rebate can also be used to create a flush finish)
on or in surface
½"
). The Collar can be adjusted upwards to relevel it
← (13/16") →
20 mm
20 mm
Material 2
OPTION 2
OPTION 4
2.5mm (2/16")
½"
)
Advertisement
