Summary of Contents for S-Box Knife Box
- Page 1 2-PORT POP-UP SOCKET BOX 3-PORT POP-UP SOCKET BOX KNIFE / SPICE / KEY / BAKERS’ BOX INSTRUCTIONS AND INSTALLATION GUIDE WE RECOMMEND THAT ALL ‘CUT-OUT’ PROCESSES AND/OR ANY ‘CUSTOM TOP’ FABRICATION SHOULD BE DONE BY YOUR SPECIALIST WORKTOP PROVIDER...
- Page 2 There are 2 (and only 2) positions to fit an S-Box™ unit: Either: A - Surface-mounted Or: B - ‘Inset’ at -20mm below surface. A - SURFACE MOUNT This simplest installation method is to insert it straight into a cut-out hole →...
- Page 3 DIMENSIONS FOR THE PRINCIPAL ‘CUT-OUT’ HOLE FOR ALL INSTALLATIONS ARE: PLAN VIEW 8mm radius 2-PORT POWER BOX = 98mm x 211mm corners 3-PORT POWER BOX = 115mm x 295mm KNIFE/SPICE/KEY/CHEF = 115mm x 425mm FOR A SURFACE MOUNT INSTALLATION THIS IS ALL YOU NEED. THE UNIT DROPS STRAIGHT INTO THIS HOLE AND THE COLLAR SITS NEATLY ON THE WORKSURFACE [FOR ‘FLUSH MOUNT’...
- Page 4 CONVERSION OF A UNIT THAT HAS A STEEL TOP AND COLLAR ALREADY FITTED WHEN IT WAS DELIVERED. IF YOU HAVE A UNIT THAT IS ALREADY PREPARED FOR A CUSTOM TOP (i.e. S-BOX CHAMELEON) YOU MAY SKIP STAGE 1 (Preparing the S-Box™) TO STAGE 2. ...
- Page 5 Then create a further 8mm wide rebate at 20mm depth from the top of the work-surface, on which to mount the S-Box, and its collar, in its new position. The radius of the collar’s corners is 8mm, so we suggest that you use a maximum 10mm radius for the rebate-routing process.
- Page 6 (when the new top is added more permanently later) > > Take the New Top off and introduce the S-Box unit into its rebated hole. Apply good quality double-sided tape (e.g. 3M) to the plate ↗...
- Page 7 STAGE 4 (Adding the new top) Peel back the tape and place the custom top into position. Using Tape allows you to have a few goes at getting the perfect position for the top before pressing it firmly home and letting the tape adhesive to bond and cure. Any final “fine-tuning”...
- Page 8 OPTION 3 OPTION 4 Original position of steel top. If still present, it MUST be removed before any custom top is fitted. OPTION 5...
-
Page 9: Port Dimensions
2-PORT DIMENSIONS 3-PORT DIMENSIONS STORAGE BOX DIMENSIONS (Knife, Spice etc) -
Page 10: Warranty And Other Information
WARRANTY AND OTHER INFORMATION AFTER 6 -12 MONTHS USE (PARTICULARLY IN VERY WARM or CENTRALLY HEATED ENVIRONMENT) THE INTERNAL RUNNERS MAY REQUIRE A TINY AMOUNT OF RE-LUBRICATION TO MAINTAIN THE UNIT’S SMOOTH OPERATION. - Page 12 AND/OR ANY ‘CUSTOM TOP’ FABRICATION SHOULD BE DONE BY YOUR SPECIALIST WORKTOP PROVIDER S-Box™ is a registered trademark of Cardinal IP Limited The S-Box™ product innovation is protected by Patents - registered to Cardinal IP Limited Cardinal Innovations Limited Battye Street, Bradford...