Related Manuals for S-Box Mini-TR
Summary of Contents for S-Box Mini-TR
- Page 1 2-PORT POP-UP SOCKET BOX MINI-TR KNIFE / SPICE / KEY / BAKERS’ BOX INSTRUCTIONS AND INSTALLATION GUIDE WE RECOMMEND THAT ALL ‘CUT-OUT’ PROCESSES AND/OR ANY ‘CUSTOM TOP’ FABRICATION SHOULD BE DONE BY YOUR SPECIALIST WORKTOP PROVIDER...
- Page 2 There are 2 (and only 2) positions to fit any S-Box™ unit: Either: A - Surface-mounted Or: B - ‘Inset’ at -20mm (13/16”) below surface. A - SURFACE MOUNT This simplest installation method is to insert it straight into a cut-out hole The fitted collar sits neatly on the worktop surface.
- Page 3 (S. Steel or Coated) ‘INSET’ (REBATED) INSTALLATION Example 2-PORT MINI TR STAGE 1 (Preparing the S-Box™) AE 1 (Preparing the S-Box™) Remove the existing Stainless Steel top - by unscrewing its 3 dome nuts. > Slightly loosen the 6 screws holding the Stainless Steel Collar and move it down to its lowest position. ↓...
- Page 4 Then create a further 8mm (5/16”) wide rebate at 20mm (13/16”)depth from the top of the work-surface, on which to mount the S-Box, and its collar, in its new position. The radius of the collar’s corners is 7/16”, so we ½...
- Page 5 ‘FALSE’ REBATE BELOW 20mm (13/16”) material: This is where the rebate is being “created” using a second material below. The upper hole now becomes the Master Cut in the worktop material. So 10/16” needs to be added to both the dims above to allow the collar to pass through that hole to sit on the second material below.
- Page 6 Take the New Top back off and introduce the S-Box™ unit into its rebated hole. Apply good quality double-sided tape (e.g. 3M) to the plate ↗ ½” ” 13/16 STAGE 4 (Adding the new top) Peel back the tape and place the custom top into position.
- Page 7 WE RECOMMEND THAT ALL ‘CUT-OUT’ PROCESSES AND/OR ANY ‘CUSTOM TOP’ FABRICATION SHOULD BE DONE BY YOUR SPECIALIST WORKTOP PROVIDER S-Box™ is a registered trademark of Cardinal IP Limited The S-Box™ product innovation is protected by Patents - registered to Cardinal IP Limited...