Table of Contents
Advertisement
Hardware Installation
1. Locate your notebook's ExpressCard slot(s).
1
2. With your notebook on, slide the ExpressCard into the
unused 34mm ExpressCard bus slot.
2
Note: Do not plug any devices into the ExpressCard until
you have completely finished the driver installation.
3
3. The "New Hardware Wizard" will launch and recognize
the ExpressCard.
4. The Windows "Found New Hardware Wizard" will pop up.
4
Select "Yes, this time only" and click "Next".
5. The "Ethernet Controller" will be detected by your system.
5
Select "Install from a list or specific location (advanced)"
and click "Next".
6. Insert the CD driver into your CD-/DVD-ROM.
7. Select "Include this location in the search" and click
"Browse" to specify the Gigabit Ethernet ExpressCard
driver located on the CD [<drive>:\Win 2000 or
WinXP&2003 (depending on your operating system)].
Then, click "Next". Note: "<drive>" represents the
letter that identifies your CD-ROM driver under "My
Computer"—e.g., if the CD is in drive D, enter "D:\
WinXP&2003".
8. Windows will automatically install the correct driver.
Click "Finish" to finish driver installation.
9. Installation is now complete and the ExpressCard is ready
to use.
LED Status Identification
• Green LED steady at 10/100Mbps
• Blue LED steady at 1000Mbps
4
Advertisement
Table of Contents
