Table of Contents
Advertisement
Hardware Installation
1. Locate your notebook's ExpressCard slot(s).
1
2. With your notebook on, slide the ExpressCard into the
unused 54mm ExpressCard bus slot.
2
Note: Do not plug any devices into the ExpressCard until
you have completely finished the driver installation.
3
3. The "New Hardware Wizard" will launch and recognize
the ExpressCard.
4. Windows "Found New Hardware Wizard" pops up and
4
finds a "Mass Storage Controller". Select "Install from a
list or specific location" and click "Next".
5
5. Select "Include this location in the search" and click
"Browse" to specify the Serial ATA ExpressCard driver
located on the CD (<drive>:\Windows 32bit\Driver).
Then, click "Next". Note: "<drive>" represents the
letter that identifies your CD-ROM driver under "My
Computer"—e.g., if the CD is in drive D, enter "D:\
Windows 32bit\Driver".
6. Windows automatically installs the correct driver.
Click "Finish" to complete driver installation.
7. Installation is now complete and the ExpressCard
is ready to use.
4
Advertisement
Table of Contents
