Dmx Mode - Evolite Air series User Manual

Advanced Calibration
(Access
Code 088)
o Mode Automatique
AUTO Mode :
Press the MENU key then ENTER, then use the DOWN key to reach the AUTO RUN menu. Press
ENTER and select the program from 1 to 8 then scroll down to Alone or Master, depending on
whether this unit is master or slave. Press ENTER to confirm this choice. Finally, press MENU 2 times
to return to the main menu. The device will then start its automatic program.
Sound Mode :
Press the MENU key then ENTER, then use the DOWN key to reach the Music Control menu. Press
ENTER and select the program from 1 to 8 then scroll down to Alone or Master, depending on
whether this unit is master or slave. Press ENTER to confirm this choice. Finally, press MENU 2 times
to return to the main menu. The device will then start its automatic program.
o DMX Mode
Each device can be individually controlled using a standard DMX-512 controller.
You must "address" each device through the "A001" menu. The filled-in address is then the base
address, address from which the device will respond.
If two devices are addressed to the same DMX address; they will then behave identically, responding
to the same DMX channels.
Wired DMX mode :
Press the MENU key and then DOWN to access the next menu. Then press ENTER then DOWN to reach
the Signal Set menu. Press ENTER and then check the DMX Cable box. Confirm this choice by pressing
ENTER.
Press the MENU key and then UP to go to the first menu. Press ENTER to select the Dmx Address menu.
Use the UP & DOWN keys to select the DMX address of the device. Press ENTER to confirm your choice.
Finally, press MENU 2 times to return to the main menu. The unit is in DMX mode, and if no DMX signal
is present, the display flashes. Then connect a DMX cable as input.
DMX mode selection via W-DMX (wireless):
In the Signal Set menu, check the WDMX IN & OUT box. This mode activates the W-DMX transmitter /
receiver. Make sure to select the same frequency group on all your devices (7 groups possible with a
different color for each group). This group is selected by pressing the button on the back of the unit,
under the Powercon type power supply. The color of the LED just above this button changes with each
press. When the devices communicate with each other, the transmitting device flashes red and the
receiver (s) flashes green.
If you want to use the DMX signal from your lyre to another DMX cable device, select the WDMX &
OUT CAB function. This function receives the wireless DMX signal and retransmits it via its wired DMX
output.
Air Wash 710z User's Manual Ver. 1.00
PAN=XXX......
Calibration
23
Page