Advertisement
FUSION EDGE (Replacement)
The cutting edge on every Pro-Tech Fusion
Edge™ Sno Pusher has a symmetric design that
can be reversed. This provides (2) unique cutting
edges ensuring long lasting performance. The
special designed Fusion Edge™ is 2" x 10" thick.
To ensure several years of service perform
periodic inspections and adjustments following
these simple guidelines:
When a Fusion Cutting Edge™ section does
need to be replaced due to wear or damage it
can easily be changed out.
Figure 5a
1. Always begin by placing the Sno Pusher on a
smooth, flat surface when making any
adjustments.
2. Remove all bolts fastening the rubber to
the Sno Pusher.
3. Reverse or replace the Fusion Edge™
Reinstall the hardware.
4. Once rubber is properly positioned begin
tightening the bolts.
IMPORTANT: We recommend using a
1/2" impact gun to ensure proper bolt
torque (55-65 ft-lb).
WEAR SHOES
Every Pro-Tech Sno Pusher® is equipped with
two hardened, abrasion resistant, bolt-on wear
shoes that are replaceable to provide seasons of
use by offering superior protection against wear
and tear. When replacement is required, follow
these guidelines:
WARNING:
Wear shoes are extremely heavy, please use
caution during the removal and installation
process.
PRO-FLOAT COUPLER
The Pro-Float™ coupler should be lubricated
periodically at all contact points to maintain full
range of motion.
STORAGE
Store the pusher in a location out of direct
sunlight and exposure to the weather to prevent
premature degradation of the cutting edge.
Properly clean the unit before storage and
remove dirt, debris, salt, etc. to extend paint life.
Pro-Tech Manufacturing and Distribution, Inc.
711 West Ave ▪ Rochester, New York 14611
888-787-4766
www.snopusher.com
1. Lift Sno Pusher slightly off ground (2"-3")
and secure before attempting any
modifications.
2. Remove existing wear shoes by
removing the shoe retaining bolts, lock
nuts and collars. Then pull the wear shoe
off the mounting pins.
3. Lubricate all sliding surfaces of the wear
shoes, mounting pins, and retaining
collars with grease or never-seize.
4. Re-install wear shoes by sliding them
over the mounting pins and securing with
the shoe retaining bolts, lock nuts and
collars.
Advertisement
